CHAPTER 3. MOWER OPERATION
103
3. STARTING MOWING OPERATION
CAUTION :
・
Read the contents of this manual thor-
oughly and carefully and keep safe opera-
tion in mind.
・
Before moving the front mower into the
working site, investigate the whole site
and get rid of all obstacles such as stones,
wood, empty tins, bottles, wires, etc for
operation safety.
・
Investigate the site for pits, mounds,
steps, slope angles, ground softness, wa-
ter pools, etc to avoid turning over, falling
down, and side-shifting.
・
Also make sure there is no danger of hurt-
ing children, animals, by-standers, etc.
and damaging nearby trees, buildings, etc.
a.
Start the engine and turn the throttle lever to the
intermediate position between the low speed (
t
)
and high speed (
r
) positions.
b.
Move the lift lever to the up position (
u
) to raise the
mower deck.
c. Release the parking brake.
d.
Push down the HST forward travel pedal gradually
to drive the front mower into the working site.
e.
Release the HST pedal gradually to stop the front
mower.
f.
Move the lift lever to the down position (
d
) to lower
the mower on the ground.
SFH240 with collector
Shift the center PTO lever to “ON” position.
After the torque of blower increasing, shift the side PTO
lever to “ON” position.
SFH240,220 without collector
Shift the center PTO lever to “ON” position.
IMPORTANT:
The lift height and PTO Iever position are interconnected
for safety as follows:
・
When the mower is lifted up higher than specified with
the PTO Iever shifted in the ON (
M
) position, the lever
is automatically shifted to the OFF (
N
) position.
・
When engaging the PTO clutch, slow down the engine
speed sufficiently for safety.
・
With the lift raised to the maximum height, the PTO
lever cannot be shifted to the ON (
M
) position. Never
attempt to move the lever forcibly, or the lever linkage
may be damaged.
(1) Center PTO lever
(2) Side PTO lever
(3) Lift lever
CAUTION :
・
PTO restriction mechanism works only
while the PTO Iever is in the ON (
M
) posi-
tion.
・
Before starting to mow, make sure that
this mechanism works properly. Be sure
to detach the drive shaft before checking
the PTO restriction mechanism.
・
Be restricted from lift up the mower deck
excessively while the mower blades are
rotating.
・
When you want to lift up the mower deck
high, shift the PTO Iever to the OFF (
N
)
position. Never attempt to shift the PTO
Iever to the ON (
M
) position while the
mower deck is lift up high.
・
Before starting to mow, make sure that the
Iift cylinder is set properly.
・
Whenever you encounter with any trouble
of the front mower, ask your dealer for re-
pair immediately.
1
2
3
Summary of Contents for SBC550FH
