SXG
14
6. LOADING ONTO OR UNLOADING FROM A TRUCK
6.1. When loading the lawn mower onto a truck, turn
off the truck’s engine, apply the parking brake to
the truck, and chock the wheels to avoid unex-
pected moving of the truck.
6.2. Pay sufficient attention to safety conditions
around the lawn mower and have it guided by
someone to assist the operator. Never allow other
persons to approach the lawn mower, especially
in front of or behind it.
6.3. When loading the lawn mower onto a truck, lift up
the mower deck fully and reverse it straight back
at sufficiently low speeds. Drive it forward when
unloading it from the truck.
6.4. If
the engine stalls unexpectedly on the ramps,
depress the brake pedals immediately and roll the
lawn mower to the ground by releasing the brake
gradually. Then start the engine and try again.
6.5. Use ramps with the same or better specifica-
tions mentioned below. When the lawn mower is
equipped with the attachments other than those
included in the specifications mentioned below,
ask your dealer for advice.
Specifications of the ramps
for the SXG 323 and SXG 326
• Length........more than 4 times the height of the
platform ...............................................of the truck
• Width(effective width) .................more than 30 cm
• Required quantity......................................2 ramps
• Capacity (one ramp) ..................more than 750 kg
• Ramps should have anti-skid surfaces.
• The above specifications are effective with the
lawn mower with the following configurations.
- The lawn mower is not equipped with any attach-
ments or a cabin than a standard mower deck
and collector.
- The lawn mower is equipped with a standard
mower deck and collector.
FIG. 9
FIG. 8
Summary of Contents for SBC550X
Page 71: ...SXG 70 ...
Page 72: ...XI ELECTRIC WIRING 71 XI ELECTRIC WIRING E TYPE ...
Page 73: ...72 SXG GE TYPE ...
Page 103: ...SBC600XH SBC550XL 102 ...
