5-4
Operation
Chapter
5
Total:
1
st
Column Format: HH.MM
This is the first of two time card “Total” columns
provided for each pair of IN/OUT punches. If used, it
will display the elapsed time between the two
immediately preceding IN/OUT punches. If not used,
the column will be blank. Column use is determined
when selecting one of eight print formats during time
recorder setup.
If the function "MAX ON" is enabled and the user
forgets to punch out, the time recorder will print
"MAX ON" in this column instead of the elapsed
time.
Total:
2
nd
Column Format: HHH.MM
This is the second of two time card “Total” columns
provided for each pair of IN/OUT punches If used, it
will display the cumulative worked time total for the
entire time card. If not used, the column will be
blank. Column use is determined when selecting one
of eight print formats during time recorder setup. If
the time card becomes full, it is possible to carry the
total over to a new time card using the feature
“deleting cards” which is described in chapter 5.
Bottom line:
The time recorder cannot print below the bottom line. The area
can be used however for manual hand written notes.
Hint
The time card print fields are defined by the time recorder and
cannot be changed.
In order to obtain a precise and correct print the time recording
cards should always have the same dimensions.
Requirements for Trouble Free Time Recording
•
Store time cards in a dry place.
•
Protect time cards against damage, especially folding, tearing and bending.
•
Protect time cards against contamination from such things as dust, oil, grease,
and steam. They could damage the time card paper or distort the bar-code.
•
Regularly inspect the time recorder’s cartridge ink ribbon and when the
printing becomes faint, replace it with a new cartridge.
•
Do not expose time cards to direct sunlight.
•
Store time cards in the boxes which they were shipped in.
Please do not keep them loose.
Summary of Contents for PERFECT 2030
