12
-
20
1 Scope of application
iSHAN centralized lubrication systems are designed to lubricate ball bearings, flat
bearings, flat slideways, circular slideways, linear guides, cams, gears, chains, etc..
iSHAN centralized lubrication systems are suitable for the lubrication of various
machines, such as lathes, mills, presses, planner, grinder, etc. It is fit to control different
lubricating points at the same time against different machines.
Operating viscosity of oil for YESA/YESB ranges from 30 to 250 cSt. at the operating
pressure of 2.5 bar. Only new lubricant shall be used.
YESA/YESA is designed to feed oil based on lubrication frequency which is controlled
by a timer and ranges from 3/5/10/15/60/60 minutes. Output volume is available with two
options, 1 to 3 c.c. or 3 to 6 c.c. per cycle. The lubricator is electric driven with a manual
pump.
2 Basic operation
2-1 Safety information
2-1.1 Before installing
!
Before installing, read the manual for the correct connection of the power. To prevent
chance of serious injury, death or property damage, disconnect the product from main
power supply before working on it.
!iSHAN
centralized lubrication systems must not be used in other purposes other than
lubricating machines.
2-1.2 Before lubricant filling
You must observe the machinery manufacturer's information on the lubricantsto
be used in the machinery.
!
Use only new oil with a permitted range of oil viscosity from 30 to 250cSt. Warning !
Motor jammed or burned due to high resistance which caused by delivering higher than an
oil viscosity of 250cSt, no pressure build-up in centralized lubrication system or
insufficient oil delivery caused by pumping lower than an oil viscosity of 30cSt result in
centralized lubrication system failure.
!
Only clean lubricant may be added.
Please never fill with used oil.
!
Never fill with chemical substances, water or hazardous fluids.
