29/54
IWQ Series Service Manual
3.3.8 C7 Mode
⋅⋅⋅⋅
Individual setup of country specifications and weighing
conditions
The particular specifications are all included by country specification set at C1 Mode. Therefore, refrain
to change the set data other than the initial setup.
Operation
Display
1. C7 Mode setup
Press the ten-key 7 and confirm it by pressing the
UNDER key.
Input data
2. Setting specifications and conditions
Setting address;
TARE key : forward
ZERO key : backward
Address A indicates higher 4 bits of 1 byte data and
address B indicates lower 4 bits.
Changing data;
CALL key: forward
PCS key: backward
Note
This data can not be changed nor looked into for
maintenance service.
A A or B
Data
3. Ending C7 Mode
Press the
UNDER key.
3.3.9 C8 Mode
⋅⋅⋅
E2ROM data readout
Operation
Display
1. C8 Mode setup
Press the ten-key 8 and confirm it by pressing the
TARE key.
Input data
2. How to read out data
The address ranges from 0 to 127.
TARE key: address going forward.
ZERO key: address going backward.
Note
This data can not be changed nor looked
into for maintenance service.
Address
Data
3. Ending C8 Mode
Press the UNDER key.
