Chapter 6 SETUP MODE
6-121 UNI-3 Service Manual
31 MODE ACCESS CODE
The dot display
1
2
3
4
5
6
7
8
9
10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
B 3 1 M O D E C O D E
The segment display
1
2
3
4
5
6
7
8
9
10 11 12 13 14 15 16 17 18 19 20 21 22 23
B 3 1 M O D E C O D E
Dot display
Segment display
Setting value
*ADJUST 4000
B31-01 ADJUST 4000
Adjust mode Startup code
*SETUP 6000
B31-02 SETUP 6000
Setting mode Startup code
*PROGRAM 9000
B31-03 PROGRAM 9000
Registration mode Startup code
*TOTAL 8000
B31-04 TOTAL 8000
Total mode Startup Code
Specify when starting up Menu/Mode
When starting up menu with [MODE] button, you may startup all modes directly via specification codes.
In BC/AC, since you can startup all modes via code specifications, you can specify codes to allow the same
operator to use.
Since you startup using operator mode when you enter the main menu, the default usable menus in settings
mode and adjustment mode are restricted.
To startup in Manager mode, operate after cancelling protect by entering password.
On the main menu screen, cancel protect using [PLU] to allow use of all menus.
Summary of Contents for Uni-3
