PRODUCT
SPECIFICATION
1. Mounting holes
2. Removable shelf
3. Reset button
4. Anti-pry bolt holders
5. Carpeted interior
6. Bolts
7. Battery
compartment
SETTING UP
ACCESS CODES
After opening the safe, wait
for the light puts out, press the
reset button once.
Yellow light (smiley face) will
flash, input a new passcode
(3-8 digits), Press “#” to confirm.
1
2
Green light (OK) will flash
indicating that your new pass-
code has been accepted.
Close the door, then rotate the
Knob counter-clockwise to
close the safe.
3
1
4
7
2
5
8
3
6
9
*
0
#
4
To set up user code:
1
4
7
2
5
8
3
6
9
*
0
#
1
4
7
2
5
8
3
6
9
*
0
#
Default User Code: 159
11” (28 cm)
9.8”
(25 cm)
13.7” (35 cm)
1
3
7
6
5
2
4
XN25
4.
7”
4.
7”
Knob
Yellow Light
“Smiley Face”
Red Light
“Battery”
Geen Light
“Ok”
Keypad
Emergency
Battery Box Slot
Key Slot
The Panel:
User
manual (1)
1
2
3
*
4
5
6
0
7
8
9
#
XN25
AA
batteries (4)
XN25
Mounting
bolts (2)
XN25
Emergency
keys (2)
XN20
WHAT’S IN
THE BOX
Emergency
battery box (1)
7.8” (20cm)
7.8”
(20cm)
9.2” (23.5cm)
1
3
7
6
5
4
7.5” (19cm)
Open the emergency battery
box cover. Install four AA
batteries into the emergency
battery box.
Insert the cable into power
jack outlet. Yellow light will
flash. Input the passcode
“159”, then press # to confirm.
open
1
2
Green light (OK) will flash,
turn the knob clockwise to
open the safe.
Locate the battery compart-
ment on the back of the door.
Install four AA batteries.
1
4
7
2
5
8
3
6
9
*
0
#
3
4
1
4
7
2
5
8
3
6
9
*
0
#
To open the safe for the first time, use the emergency
battery box provided.
Default User Code: 159
GETTING
STARTED
Press the emergency key slot
cover on the right of the panel
to open the cover.
Insert the emergency key into
the keyhole. Turn the key
counter-clockwise.
Do not release the key.
1
4
7
2
5
8
3
6
9
*
0
#
1
1
4
7
2
5
8
3
6
9
*
0
#
2
Hold the key, and turn the
knob clockwise.
Pull the door to open the safe.
1
4
7
2
5
8
3
6
9
*
0
#
3
4
To open the safe for the first time, use the
emergency key provided.
NOTE: If the “smiley face” flashes with three
beeps, then your passcode setup has been
rejected. Please try again.
Shelf Height: 0.8”
If battery’s low (red light indicator flashes) or dead,
please replace fresh batteries.
REMOVE
THE SHELF
To remove the shelf, make sure the safe is empty:
Left the shelf upwards for.
Rotate the shelf in 15°, then pull
the left side towards you to get
it out of the safe.
1
2
