DMP116it | 1
st
Issue rev. a | 03/2022
pag.
MVC503R-MB Configuration Tool
–
Product Manual
6
Figure
1.
User interface after the serial converter connection
From the “
Settings
” menu on the top of the window is possible to
select:
•
“
Read converter parameters
”: read t
he modbus communication parameters of
the converter
•
“
Write converter parameters
”:
write the modbus communication parameters
in the converter (the values have to be configured in the comboboxes in the
“
Modbus Configuration
“ area).
This options allow to set the communication parameters on the PC side (master).
Figure
2.
Settings menu
From the “
Language
” menu on the top of the window it will be possible
to change the
language of the Configuration Tool. The selectable languages are: Italian and English.
Figure
3.
Language menu
From the menu “
Configuration File
” it will be possible:
•
To load
into the actuator the configuration parameters specified in the selected
file (.csv format)
only after the modbus connection is successfully
established (“CONNECT” button)
.
•
To save
a configuration file including all the values present into the software
interface (values into the areas: Actuator Configuration, Valve Configuration and
modbus parameters (baud rate, parity bit and stop bit)).
•
To read
from the configuration file the parameters and show them into the
software interface.
For the two last functions the Modbus connection with the actuator is not
required.
