iSMA-B-LP Room Panel/Modbus
version 1.3
www.gc5.pl
Page 39 / 121
6.12.2
Operating Mode is false (see Operating Mode )
In case, when Operating Mode is
“false”
, the user changes Setpoint indirectly by changing
Offset.
When SETPOINT_CONFIGURATION bit 3 Setpoint Display is
“
f
alse”
then OffsetSetpoint is
displayed.
When Offset is in Edit Mode, its value, unit and name flash with frequency calculated
according to the value stored in SUBMENU_ICON_FLASHING_TIME register.
Pushing the up arrow button increases Offset Setpoint value with the STEP stored in
SETPOINT_STEP register (for detailed functioning see
SetpointSTEP
).
If entered value is higher than the value stored in OFFSET_RANGE register, the actual
Offset_Setpoint value is overwritten by the value in that register.
Pushing the down arrow button decreases Offset Setpoint value with the STEP stored in
SETPOINT_STEP register (for detailed functioning see
SetpointSTEP
).
If entered value is lower than the negative value of the OFFSET_RANGE register, the actual
Offset Setpoint value is overwritten by the value in that register.
When SETPOINT_CONFIGURATION bit 3 Setpoint Display is
“true”
, procedure is analogical,
but instead of displaying Offset Setpoint and Offset Name on LCD display, Effective Setpoint
with Setpoint Name is displayed.