iSMA-B-MAC36NL User Manual
Version 1.4
www.gc5.pl
Page 28 / 51
To put the controller into the debug system console mode, plug-in the USB-to-MiniUSB cable.
This makes the system console available at the debug port, at a predefined serial rate: 115200,
8, N, 1.
More detailed instruction is described below:
1.
Connect to controller’s debug port using the USB cable.
2.
Start terminal emulation software on your PC. We recommend PuTTY, which can be
downloaded from https://www.chiark.greenend.org.uk/~sgtatham/putty/latest.html
3.
In the category tree expand “Connection” branch and choose “Serial”.
4.
Set the “Serial line to connect to” USB COM port, in which the controller has been
detected. It is possible to check which port is in use in Windows Device Manager.
5.
Set the “Configure the serial line” fields as shown in the figure below
Figure 25. COM port settings in PuTTY
6.
In the Category tree click “Session” and choose “Connection type” as a “Serial”.
7.
Click “Open” button at the bottom of the PuTTY window.
8.
You can observe the system logs and make their dumps for service purposes by GC5