iSMA-B-MAC36NL User Manual
Version 1.4
www.gc5.pl
Page 44 / 51
•
Standby mode – the panel is in energy-saving mode, the backlight is switched off.
Turning back from this mode to Normal mode is executed after the user’s activity
(touch) and takes around 10 seconds. The last open side is displayed.
The iSMAHDMI component consists of the following slots:
Figure 38. iSMA HDMI Property sheet view
•
Status – status of HDMI Service, available states:
-
OK – service is working properly
-
Fault – some fault has occurred
•
Fault Cause – fault cause description:
-
None – there is no fault
-
Couldn't connect to HDMI server. Connection refused – service cannot connect with HDMI
– the iSMA-B-MAC36NL software is not up to date or there is a problem with a hardware.
-
Service is duplicated – HDMI Service is added twice
The slots assigned with the Screensaver mode:
1.
Screensaver Enabled - this slot switches on or switches off the Screensaver mode („true”-
mode enabled, „false”- mode disabled). By default the Screensaver mode is active.
2.
Screensaver Time – this slot contains the time value in hh:mm:ss format. This time starts
counting down when there is no user activity on the display (no touch). When the time
elapsed the display goes to the Screensaver mode. The default value is 2 minutes.
3.
Screensaver Path – the slot contains the path to the custom image, which is displayed on
the screen in the Screensaver Mode. The default image for the screensaver is shown below.