Off / On
Auto Power Off
Volts AC
Volts DC
Warning
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
Safety sheet
. . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
. . . . . . . . .
Read First
Safety Information
To ensure safe operation and service of
this Clamp-multimeter, read these
instructions completely before use and
comply with them fully when using it.
Failure to observe these warnings can
result in severe
injury
or
death.
30min
TEST EQUIPMENT RISK ASSESSMENT
Users of this equipment and or their
employers are reminded that Health and
Safety Legislation require them to carry
out valid risk assessments of all electri-
cal work so as to identify potential
sources of electrical danger and risk of
electrical injury such as from inadvertent
short circuits. Where the assessments
show that the risk is significant then the
use of fused test leads constructed in
accordance with HSE guidance note
GS38 “ Electrical Test Equipment for
use by Electricians” should be used.
Symbols as marked on the
instrument and instructions.
Risk of electric shock
Refer to operating instructions.
DC measurement
Equipment protected by double or
reinforced insulation
<
Battery
Earth
AC measurement
Conforms to EU directives
E
May be used on uninsulated
Conductors.
Warning
Do not apply more than 600V rms
ac between the instrument terminals
and earth ground .
-
Avoid working alone, so assistance can
be rendered if required.
-
Do not use test leads or the instrument
if they look damaged.
-
Do not use the instrument if it is not
operating properly or if it is wet.
-
Use the instrument only as specified in
these Operating Instructions, or the
protection provided by the instrument
may be impaired.
-
Use extreme caution when working
around bare conductors or bus bar.
Contact with a hazardous live conduc-
tor could result in electric shock.
-
Wear appropriate Personal Protective
Equipment if working where hazardous
live parts are accessible.
-
Do not hold the instrument beyond the
Tactile Barrier, or allow fingers to pro-
trude past it.
The purpose of the barrier is to provide
adequate clearance between the op-
erator and a hazardous live conductor.
-
Use caution with voltages above 30 V
ac rms, or 60 V dc. These voltages
pose a shock hazard.
Warning
Do not apply more than 600V rms
dc between the instrument terminals
and earth ground .
A7-4
ICM
Instruction Manual
ICM A7-4
Electrical Clamp-Multimeter
EN
