Note that if a 50Hz synchronous motor turntable is connected to a PowerStation
outlet, selecting 67.5 Hz will increase the turntable speed to 45rpm. Similarly if a
60Hz synchronous motor turntable is connected to a PowerStation outlet, selecting
81 Hz will increase the turntable speed to 45rpm.
Night Mode
Night Mode switches off the main display and dims the indicator LED's for
minimum visual impact. To enter Night Mode press and hold the “
DSP
” button for
two seconds. To revert to normal display mode press the “
DSP
” button briefly.
Over Temperature
If the ambient temperature is too high to allow adequate cooling, or the connected
load is inappropriate, the PowerStation will shut down if either channel heatsink
temperature exceeds 62 degC.
The display will momentarily show “OFF” then “HOT”. The left or right “
T
”
indicator will flash indicating which channel was over temperature. The
PowerStation can not be turned on again from the front “
PWR
” button.
To reset, take appropriate steps to ensure the condition cannot be repeated. Check
that the connected load is suitable and that all ventilation requirements are met.
Allow an appropriate time for the unit to cool. Turn off the rear panel Main Switch
and wait ten seconds. Switch the rear panel switch back on to enter standby. The
PowerStation can then be switched on and should then operate normally.
