ORIGINAL INSTRUCTIONS
6.5
Smoothing disk mounting
1.
Before assembling the smoothing disc adjust the blades
horizontally, i.e. resting on the ground.
2.
Place the disc on the ground with the smooth and flat part on the
floor.
3.
Manually move the power trowel over the disc and fit the four
blades in the special joints present on the disk.
4.
Make a small move on the floor to make sure that the disk and the
blades are correctly joined.
Disassembly is obtained by unlocking the blades from joints and
removing the power trowel from above the disk.
34
Dangerous movements
Mounting and dismounting of the smoothing disk must be carried
out with the machine turned off. The rapid rotation of the blades
before fitting may result in damage to the disk system.
