©Isothermal Technology
Page 7 of 61
914 millisKanner manual Iss. 1.00
for temperatures up to 31ºC decreasing linearly to 50% RH at 40ºC
Equipment is for operation at installation category II (transient voltages) and
pollution degree II in accordance with IEC 664 at altitudes up to 2000 metres
Always use the power supply supplied
This equipment is for use in moderate climates only. NEVER use the equipment in
damp or wet conditions
Avoid excessive heat, humidity, dust & vibration
Do not place liquid filled containers on the equipment
Do not use where the equipment (or any associated accessories) may be subjected
to dripping or splashing liquids
Ensure that the switch on the electrical supply outlet used is easily accessible to
allow the unit to be switched off
Ensure that tabletop equipment is placed on a solid, level surface, which is able to
support its weight (and that of any attached accessories)
Ensure all cables and wires are routed safely to avoid tripping: also to avoid sharp
bends and pinches
Clean only with a damp cloth. Do not wet or allow moisture to penetrate the unit.
Do not use solvents. See section 4.1 for details of cleaning procedure
The product should be subjected to regular in-service inspections as required by
local regulations; a yearly interval is suggested
Do not apply earth test currents to any terminal/connector or to the shrouds of the
RS232 connectors
This equipment contains no user-serviceable parts. Refer all repairs to qualified
service personnel. Contact Isothermal Technology or one of our appointed
distributors for details of approved service outlets
1.3
1.3
1.3
1.3
A Quick Tour of Your millisKanner
A Quick Tour of Your millisKanner
A Quick Tour of Your millisKanner
A Quick Tour of Your millisKanner
On the top panel of your millisKanner you will find the binding posts (five per channel)
and miniature thermocouple connectors for the eight inputs channels , the “left”/”right”
channel select buttons, the green “power” LED and eight red LEDs that indicate when a
channel is selected: