Page 14 of 49
TTI-22 Iss.04– 11/15
6.
Putting TTI-22 into Operation
1.
Check if the calibration numbers on these parts are identical:
-
on the factory or UKAS calibration certificate
-
directly at the sensor
-
on the parameter printout, if existent ("Configuration Parameters")
2.
Check if the serial number on TTI-22 (on the rear side of the instrument) matches the number on
the optional parameter printout ("Configuration Parameters").
3.
If the above-mentioned numbers do not match, be sure to contact the manufacturer or supplier of
the instrument.
6.1
Assembling the Measuring System
Warning:
• Only use the delivered power adapter, Mat. No. 43768.
• Observe the correct polarity when placing the batteries.
• Only use 1.5 V AA batteries or 1.2 V AA rechargeable batteries of the same type and charge
condition.
1.
Place two 1.2/1.5V AA batteries in the battery compartment at the rear of the instrument or
connect the delivered power adapter.
2.
If necessary, connect the sensor to the measuring cable (some sensors are supplied with non-
detachable cable).
3.
Plug the sensor cable into the socket with the designation "CH 1" on the front side of the instrument.
Fig. 6 - 1
TTI-22 with connected sensors
