62
Interior blinds Cetta 35, 50 - Economy
Instructions for measurement
Measurements
Cetta 35,50 - Economy blind can be located either into the hole, or in front of the hole with the assembly on the ceiling or on the
wall.
The width and height are measured in the following manner:
w.... (width)
a) Mounting into the hole
The actual width of the hole is measured in three points, dimensions decreased by 5 mm than the measured value is to be
stated in the order form.
b) Mounting on the hole
The width of the hole which the blind is to cover is to be stated in the order form.
The width of the blind is produced with a precision of millimetres up to the weight of 3,150 mm.
Dimensions outside the stated
limits are recommended to be consulted with the manufacturer.
h .... (height)
The total height, including upper profile and the holder of the blind is measured.
The height of the blind is produced with a precision of millimetres up to the height of 3,000 mm.
Dimensions outside the stated limits are recommended to be consulted with the manufacturer.
Side guiding:
Cetta 35,50 - Economy blind is produced with side guiding (guiding wire 2.2 mm) as well as without side guiding.
Length of control:
Unless stated in the order otherwise, 2/3 of the height of the blind is selected in the standard variation (for
control by the tilting unit cord). The length of the cord is stated by the producer (always connected to the lower profile of the
blind)
w
h
Summary of Contents for Cetta 35
