86
87
INTERIOR BLINDS
86
87
Assembly of the blind into the created pocket
(ceiling/wall)
Assembly of the blind into the reveal on the window frame
(ceiling/wall)
Assembly of the blind into the reveal on
the expansion frame
(ceiling/wall)
There are two alternatives for all three basic assembly types:
a) Cover box
ASSEMBLY PROCEDURE:
1. Measure the hole and compare with already prepared blind, check the control mechanism.
2. Allocate the blind holders so they do not interfere with the cloth strips.
3. Fix the holders horizontally.
4. Insert the blind into the sleeves in the holders and secure. Do not tighten screws for the sleeves.
5. Prepare the passage for control using the handle or the cord. If there is an electric control, connect the socket.
6. From the inside passage attach the handle; if the drift is long, shorten it to the necessary length. Stretch the
endless cord through the created hole. Attach the cover for the passage of the cord.
7. Tighten the screws on the sleeves in the holders.
8. On the lamella guides attach the guiding bars which are already fi tted with the holders for the guiding bars
and attach them on the window frame or into the reveal (for assembly into the reveals, the guiding bar holders
are not used and the guiding bar is attached through the holes created in the body of the guiding bar). The
guiding bars must be attached in the middle of the upper profi le of the blind.
9. Lower the blind into the lower position (attach the holders for wires if the blind has wire guided lamellas). At
the same time, check that the guiding bars or wires do not clamp the lamellas. Check the vertical position of
the guiding bars.
10. When the lamellas are tilted, attach the cover box to the holders, insert the prolongation of the holder (tigh-
ten the fi xation screw) into the pocket created on the cover metal sheet and secure the cover sheet using the
screw through the hole in the holder for the blind .
11. The blind driven by the engine can be inspected using the assembly cable or adjust the end positions of the
engine and the connection to the supply cable.
12. Fix the holders of the handle in the interior. Connect the control switch according to the connection diagram
supplied.
b) The cover box incorporated into the heat-insulation system or the peripheral shell
ASSEMBLY PROCEDURE:
1. Attach the blind holders.
2. Attach the cover sheet (can also be with side parts), insert the prolongation for the holder (tighten the fixation
screw) into the pocket created in the cover sheet and secure through the hole in the holder with the screw
(texem).
3. Drill the passage for control by the handle.
After heat insulation or production of the peripheral shell, the assembly of the blind is according to the previous
manual.
Summary of Contents for Cetta 35
