92
93
INTERIOR BLINDS
V-LITE Roof Blinds
MEASUREMENT OF THE WINDOW
Take measurements as indicated in the diagram. Measurements are taken at the top of the frame of the window wing, not at the glazed area.
The minimum depth for assembly is 40 mm.
THE WIDTH AND THE HEIGHT OF THE LIGHT HOLE IN THE WINDOW WING IS MEASURED IN THE FOLLOWING MANNER:
w.... (width)
The measurement is from the left top to the right top of the window frame on the top in the place of fixation of the blind.
The width of the blind is produced in a precision of millimetres from the width 300 mm up to the width 1,200 mm.
It is recommended to consult the manufacturer for dimensions outside the stated limits..
h .... (height)
Measurements are taken the same as the width from the upper top to the lower top of the window frame and is written into the order form
of the blind.
The width of the blind is produced with a precision of millimetres from the width 300 mm up to the width 1,200 mm.
It is recommended to consult the manufacturer for dimensions outside the stated limits.
In the order form, it is necessary to specify:
1. dimension
2. type of window and identification number of the window.
3. angle of the glazing bar (90°, 96°, 100°, 102°, 105°)
W
H
Summary of Contents for Cetta 35
