MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 1. 6. 2017
20
4.3. CRANK HANDLE OPERATION WITH EYE
– FOR OUTDOOR OPERATION
In this case, the screen box is fitted with a long, metal eye. A crank handle rod with a hook can be hooked onto this to
operate the screen.
After operating the screen, unhook the crank handle rod and store it indoors in a dry area.
5.
INSTALLATION OPTIONS
5.1. FITTING THE U-CHANNEL 10X10X10X1.5 MM, HORIZONTAL
If a loose U-channel is supplied, it can be used to conceal the electrical
cable for the motor so that the cable can run on top of or behind the
box from one side to the other. Press the cable into the U-channel and
apply a thin layer of silicone caulk to one side of the U-channel, then
press the side of the channel with the caulk flat against the top of the
box, neatly aligned and parallel to the rear edge of the box
.
5.2. FITTING THE U-CHANNEL 10X10X10X1.5 MM,
VERTICAL
To fill the gap behind the box in line with the guide rails, you can use a
U-channel that is available separately.
Attach the U-channel to the back of the box with caulk, with the back of
the profile in the same plane as the console.
5.3. FITTING THE 30X20X2 MM ANGLED PROFILE
TO THE BOX
This angled profile can be fitted on top of the box:
fig. 34
fig. 35
fig. 36
