7
Section
4
OPERATION
General:
After having properly installed and set up the ma-
chine, it is now ready for stitching. It is recom-
mended that each operator be instructed as to cor-
rect operating procedure and normal adjustments
necessary for varying work conditions.
WARNING
Prevent accidents by following these rules:
1. Do not put your hands near area to be
stitched when machine is operating.
2. Turn the power off when the stitcher
is not in use.
CAUTION
AVOID DAMAGE TO YOUR
STITCHER BY FOLLOWING
THESE RULES:
1. Never operate your stitcher with wire
feeding unless you have work material
between the clinchers and formers.
2. Do not drive one stitch on top of an
other.
Changing Work Thickness:
(Figure 5)
Changing work thickness will probably require a
change of the wire draw length used to make a
stitch. This is done by raising or lowering the face
plate. Change face plate position as follows:
1. Switch off power, loosen the face plate screw
(Index A).
2. Turn grip release lever (Index B) clockwise to
raise face plate for more wire draw or counter
clockwise to lower face plate for less wire draw.
NOTE: Raising face plate too high may: (1.)
Prevent the grip from closing and drawing wire;
(2.) Prevent proper compression resulting in a
loose stitch.
3. Retighten faceplate screw.
A
B
(CTTT2605 Scene 5)
Figure 5