Page 23
| (678) 261-7611 |
10)
Water from the system tastes the same as tap water
a)
Incorrect installation. Verify all connections on the system.
b)
The RO membrane is not installed in the membrane housing. Ensure that the membrane has
been installed.
Section 4: Glossary and Terms to Know
Add-On Kit (#ACL1):
Filter add on kit for adding additional in line filters to an existing system. Comes
with quick-connect elbow fittings, filter clamps, and additional tubing
Alkaline Remineralization Filter* (#FA15):
6th stage. Remineralizes the RO water and neutralizes the pH
Automatic Shut-Off Valve (#AAS2):
The white, four way valve that automatically starts and stops the
system’s water production through pressure signals
Check Valve (#ACV1K):
One way valve that does not allow water back into the membrane housing. Looks
like a standard elbow fitting and is located on the “Pure” water port of the membrane housing
CTO Carbon Block Filter (#FC15):
3rd stage. 5 micron 10” carbon block filter. Further removes any
residual chlorine, tastes, and odors before the water reaches the RO membrane
Drain Saddle (#ADS1):
Attaches to your under-sink drain pipe to secure the drain tube coming from the
system
Drinking Faucet:
The output source for the RO water. The faucet is a non air gap faucet with a ¼” tubing
connection. The optimal sized counter-top hole for the faucet is ½”, but holes up to approximately 1 ½” will
work
Elbow Fittings (#4044K):
Quick connect elbow fittings used on the system (except for on the membrane
housing and cap). ¼” tubing connection and ¼” NPT male thread
Elbow Fittings on Membrane Housing (#4042K):
Quick connect elbow fittings used on the membrane cap
and drain port of t
he membrane housing. ¼” tubing connection and ⅛” NPTF male thread
Feed Water Adapter:
Goes in line with your cold water line and branches off a water supply line to the RO
system. Can adapt to ⅜” and ½” cold water lines
Flow Restrictor (#AFR300):
Limits the drain water flow, keeping pressure in the system and allowing the
RO process to occur
Flow Sensor Switch* (#FSS):
Detects water flow to turn the UV filter on and off as needed
GAC Filter (#FG15):
2nd stage. 5 micron 10” granulated activated carbon filter. Removes chlorine, tastes,
and odors from the water
GPD:
Gallons Per Day
Housing Wrench for Membrane Housing (#AWR1):
Housing wrench used to screw on and unscrew the
membrane housing cap
Housing Wrench for Stages 1, 2, and 3 (#AWR2):
Housing wrench used to screw on and unscrew the
stage 1, 2, and 3 filter housings
Ice Maker Kit (#ICEK):
Add on kit that allows you to run water from the system to your fridge ice maker
or fridge water dispenser
Leak Stopper (#ALS1):
Protects from any possible leaks by cutting off the water supply when the sponge
absorbs water
Membrane Housing and Cap (#NW12):
Horizontal housing that the RO membrane is inserted into
Membrane Housing O-Ring (#ORM):
2 ½” O.D. O-ring used to create the seal between the membrane
housing and the membrane cap
Post Carbon Filter (#FT15):
5th stage. Works as a final polishing filter before the water is delivered to the
faucet
PPM:
Parts Per Million, a unit used to measure TDS readings
