Page 12
6.5
Before twisting the housing cap back on, make sure the
O-ring is seated at the end of the
membrane housing
as shown in figures 8 and 9.
This is very important to avoid leaking
and damage to the O-ring.
6.6
Place the membrane housing cap back on and hand tighten it, then use the housing wrench
to tighten it another ¼-½” of a turn. Do not over tighten.
6.7
DO NOT reconnect the tubing to the fitting on the cap at this point (will be done in system
start up).
Step 7: Tubing Hook Up (see figure 5 above to see letters not shown below)
Summary of Contents for RCC1P
Page 26: ......
