Step 9.
Connect the equipment sewage pipe and clamp it to ensure a secure connection. Connect the
equipment overflow pipe and clamp it to provide a secure connection as well. The sewage and
overflow outlet is then inserted into the tubes, and the stainless steel clamp is locked and firmly
attached outside to prevent high water pressure during sewage discharge. This could cause the
sewage hose to break loose and leak sewage.
Step 10.
Insert the overflow pipe and the sewage pipe of the water softener into the sewage outlet.
Step 11.
Re-attach the lid. The machine's cable needs to be plugged back into the control panel. Ensure
it does not fall off.
Step 12.
Plug in the power adapter and connect the other end of the socket to the power supply.
Step 13.
Place the bypass in the
bypass position
.
Step 14.
Slowly
turn on the main water supply
.
Step 15.
Open a cold water tap
nearby and let the water run for a few minutes until the water runs
clean or until the system is free of foreign material caused by plumbing work.
Step 16.
Add water to the resin tank:
After connecting the pipes and power supplies,
start regeneration
and
slowly open the water
inlet valve to the 1/4 position
(rapid opening will cause equipment damage and resin loss). At first,
you will hear the air exhaust sound coming from the sewage pipe. Wait for the "BACKWASH"
sign on display to stop flashing, then unplug the power supply,
power off
the device, and keep the
device in the backwash state.
After the air in the resin tank is wholly discharged (the exhaust sound disappears and water steadily
flows out of the sewage pipe),
completely open the water inlet valve
and flush the resin tank until
the water is completely clean. The flushing time should not be any less than 10 minutes, and the
tank's air should be completely exhausted.
All keys will lock after 3 minutes during standby. Press and hold the “MENU” key for
3 seconds to unlock.
Step 16. a.
To perform the
regeneration processes,
press and hold the
"↑" / "↓"
keys for
3
seconds
in the unlocked state to enter the user menu settings.
Step 16. b.
Press and hold the
"SET/REGEN"
button for 3 seconds to enter manual regeneration
mode, then choose immediate regeneration.
Step 17.
Add water to the brine tank:
After completing the above steps,
connect the power supply
. The control valve will continue to
run the remaining regeneration steps and return to regular use after completion. This step will take
about
one hour
to complete. The process will replenish a certain amount of water in the brine tank
to ensure the next regeneration's effectiveness and is an essential step.
Step 18.
Resin regeneration:
After the above steps are completed, let the equipment
stand for 24 hours
to produce enough
concentrated brine in the brine tank. Then start a complete regeneration process to ensure that the
resin meets the requirements of regular use.
Start the regeneration
, and the valve will begin to run
the regeneration process automatically.During this period, do not cut off the water or power, and do
not touch any buttons on the valve (be sure to follow the procedure through the entire regeneration
process and return to regular use).
| (678) 261-7611 |
support@123filter.com
