T
he
reference
in
surface
TreaTmenT
International
Surface
Technologies
i s t s u r f a c e . c o m
30
DCM600 to 1800 - Instruction Manual
Warning :
Do not use jumper cables telephone. They have a cross connection and can damage
controllers. Cables designed for use with the DCT1000 are available from Dwyer Instruments
(Model-2 DCAC02 2 feet measure, then measure DCAC04 4 feet, etc.).
Warning :
Before installing please go DCP100A/200A Please carefully review the terms
of the operations specifications. Some operating systems, especially in applications of
pneumatic transmission, may be that the static pressure or suction have conditions that
exceed the capacity of the module pressure DCP100A/200A.
1.2.5 Mode in a continuous cycle
The master controller has several operating modes available for different applications. Starting with the
basic mode, it is capable of operating with a continuous cleaning cycle. It can be initialized by placing a
jumper between the input and the common limit High or by omitting the manual entry of the connection
of the ordinary. The management of this cycle has three installation parameters: timing off, on time and
cycle. The timing off the solenoid operates specifically on the schedule and the time interval between
the end of impulsion and early the next. The delay of a delay cycle allows to program up to 255 minutes
between the end of a complete cleaning cycle and the beginning of the next. This allows additional
options to define a clean profile.
1.3 dCP installation
For these conditions, there are a number of additional products Dwyer pressure that can be used to meet
your application requirements, all of which can be forwarded to the Controller Timer Dwyer DCT1000
Dust. For more information on these products and Dwyer, please call them at 219879-8000 or visit them
on the web at : www.dwyer inst.com-or-www.dust controls.com .
1.0 — installing tHe dCt1000 (Cont’d)
