iStore - Installation Manual - June 2020
33
valves as
required by federal/state regulations & shall incorporate a 500kPa Pressure Reduction
Valve. Installation of a Pressure Limiting Valve does not comply with manufactures installation
instructions. Failure to incorporate a 500kPa Pressure Reduction Valve will void this warranty.
13. The electrical system components must be installed in a domestic application and connected to a
240V power supply by a qualified electrician in accordance with AS3000.
14. iStore reserves the right to alter the design, components or construction to its iStore Hot Water
System. Such alterations shall not constitute a defect in design or construction under this
Warranty. See Warranty Table on next page.
15. Any claim under this Warranty must include full details of the defect and/or damage to the iStore
System. All claims must be made within one (1) month of detection of the defect.
16.
Dated proof of purchase is required prior to commencement of any work under this Warranty.
This Warranty does not apply to any defects or damage NOT due to faulty factory parts or
workmanship including, but not limited to, defects or damage caused by or resulting from: (a)
accidental damage, storm damage, vandalism, failure due to misuse or abuse, or neglect of
any kind; (b) incorrect or improper installation of the iStore Hot Water System, including but
not limited to, installation otherwise than in accordance with the instructions contained in the
installation manual supplied by iStore or incorrect system selection; (c) alteration or repair of the
iStore Hot Water System other than by a licensed plumber/electrician/refrigeration mechanic
or by an approved iStore agent; (d) attachment of any parts or accessories other than those
manufactured or approved by iStore; (e) freezing in regions with minimum temperatures below
-10°C; (f) the power supply to the iStore Hot Water System being cut; (g) power surges; (h) animals,
birds and/or rodents; (i) excessive water pressure, negative pressure (partial vacuum), excessive
temperature, corrosive atmosphere, faulty plumbing and/or electrical wiring; (j) sludge/sediment
as a result of connection to a water supply from unfiltered or treated sources i.e. spring, dam,
bore, river or town supply from a bore; (k) contamination and corrosion from particles in the water
supply; (l) serial tags/stickers on any of the components being removed or defaced; (m) the iStore
Hot Water System being relocated from its original point of installation; (n) the water stored in the
cylinder exceeding at any time the following levels:
(
o) If penetrations are made through the tank
skin by the installer, warranty will be void immediately; (p) Damage caused by transport; (q) if the
system has been re-installed at a location other than the original location.
Terms and Conditions of Warranty
Total hardness
200 mg/litre or p.p.m
Total dissolved solids
600 mg/litre or p.p.m
Electrical conductivity
850 μS/cm
Chloride
250 mg/litre or p.p.m
Magnesium
10 mg/litre or p.p.m
Sodium
150 mg/litre or p.p.m
pH
Min 6.5 to Max 8.5