70
Changing the Oil
1. Place a container under the drain plug to receive oil.
2. Remove the plugs indicated in the figure to discharge the oil into the container.
3. After installing the drain plug by tightening it to the specified torque (84 Nm), refill
the rear axle differential with new oil through the oil level plug hole up to the lower
edge of the hole.
4. After refilling, confirm that the oil level is up to the lower edge of the oil level plug
hole.
5. Install the oil level plug by tightening it to the specified torque (84 Nm).
POWER STEERING FLUID
The power steering wheel fluid level must be checked and it must be changed
according to the Maintenance Schedule.
Checking the Power Steering Fluid Level
The fluid level is correct if it is between the "MAX" and "MIN" lines on the reserve tank.
If the level is lower than the "MIN" line, add fluid up to the "MAX" line. The reserve tank
is located at the engine compartment left of the engine. When you have finished
checking the fluid level, securely install the cap and cover.
Changing the Power Steering Fluid
Draining
1. Apply the parking brake firmly and chock the
rear wheels.
2. Firmly apply the head of the jack to the jacking
point.
3. Raise the vehicle until the front wheels are
completely clear of the ground.
Summary of Contents for NOVOULTRA E6 2019
