17
When pressed the button, fresh air is taken from outside and blower works
at highest speed by increasing gradually.
When pressed again, the control panel returns to its previous position.
While in max. position, if any key is pressed, max. is deactivated and returns to its
previous position.
Hot-Cold valve control button; When pressed the button, if blue led is on, it
is in summer position. Hot water does not go to heater.
Pressing the button, red led position I lights and the valve opens in
position by 1/2. In this situation warm air is obtained.
When pressed once more, red led position II lights with position I. Valve is fully open
in position II. Heater operates at full capacity and it is in winter position. When
pressed again, red led goes out, blue led is on, it returns to the summer position.
When pressed the button, green led lights. It is used for defrosting
windshield.
When pressed the button, green led lights. Some air is directed to the
windshield and nozzles.
When pressed the button, green led lights. All of the air is directed to the
nozzles.
When pressed the button, green led lights. In this position, fresh air
needed by front heater is taken from outside.
When pressed the button,
green led lights. In this position, air needed
by front heater is taken through the vehicle.
Summary of Contents for NOVOULTRA E6 2019
