69
TRANSMISSION OIL
Change the transmission oil according to the Maintenance Schedule.
Checking the Oil Level
1. Remove the oil level plug.
2. Check whether the oil level is up to the lower edge of the oil level plug hole. The
correct oil level range is between 0 and 10 mm (0 and 0.39 in) below the bottom of
the level plug hole. If the oil level is too low, add oil through the oil level plug hole.
3. Fasten the oil level plug to the specified torque (39 Nm). Also check to see if there
are any transmission oil leaks
Changing the Oil
1. Place a container under the drain plug(s) to receive oil.
2. Remove both oil level plug and drain plug(s) to discharge the oil into the container.
3. After installing the drain plug(s) by tightening it to the specified torque (39 Nm), refill
the transmission with new oil through the oil level plug hole up to the lower edge of
the hole.
4. After refilling, confirm that the oil level is up to the lower edge of the oil level plug
hole.
5. Install the oil level plug by tightening it to the specified torque (39 Nm)
REAR AXLE DIFFERENTIAL GEAR OIL
The rear axle differential gear oil level must be checked for its level and it must be
changed according to the Maintenance Schedule.
Checking the Oil Level
1. Remove the oil level plug.
2.
Check that the oil level is up to the lower edge of
the oil level plug hole.If the oil level is too low, add
oil through the oil level plug hole.
3.
Fasten the oil level plug to the specified torque (84
Nm).
Summary of Contents for NOVOULTRA E6 2019
