26
EOT CUT
Automatically cuts the media when an EOT command is received from the host. This
setting will advance the media past the cutter then cut the media off.
Default “No”.
Setting: Yes or No
PRE-BUFF
Helps hosts with slower data transfer rates to plot using a faster speed without the stop
and start gaps. This setting uses the onboard memory to buffer the incoming data before
plotting the image.
Default “Off”.
Setting: On or Off
NOTE:
Memory can be expanded up to 32 Meg.
NIB SAVE
Helps nib life on vertical boarders that are always turned on.
Default “Auto”.
Settings: Auto (automatically shifts plot left and right)
Lock@1
(will lock image at that position)
Lock@2
Lock@3
Lock@4
Lock@5
Center
(will center the image)
NOTE:
Auto setting is recommended to help improve nib life. If the print head is missing
a nib the plot can be shifted and locked in place using the Lock@ setting.
BEEPER
Controls the audible signal for error messages such as media out warning. This sound
can be changed.
Default “Off”.
Settings: Off
(turn beeper off on errors)
Solid
(beeper on continuous until error cleared)
Fast P
(beeper will pulse at a fast rate)
1 Min P
(beeper will pulse every minute)
3 Sec P
(beeper will pulse every 3 seconds)
5 Times
(beeper will pulse 5 times then turn off)
NOTE:
Error condition must be cleared in order to continue plotting.
OFFL ERR
When set to “Yes”, with an error condition the plotter interface will go offline to the host.
Default “Yes”.
Settings: Yes or No
BUSY OFFL
When set to “Yes”, the plotter interface will assert the busy line to the host when the
plotter goes offline.
Default “No”.
Settings: Yes or No
