MPC5xxx/SPC5 14-pin 2.54mm Galvanic Isolation
Adapter
Galvanic isolation is used where two electric circuits must communicate, but their grounds
may be at different potentials. It is an effective method of breaking ground loops between the
two circuits. Galvanic isolation is also used for safety, preventing accidental current from
reaching ground through a person's body.
iSYSTEM Galvanic Isolation Adapters provide a
basic
isolation that withstands high voltages.
To prevent injury to personnel when dealing with potentially hazardous voltages it is
mandatory to have a second protection measure in place, in case the first insulation barrier
fails. This is termed double or, reinforced isolation. How should a double isolation be
implemented depends on the use-case or application setup.
It is a user's responsibility to check local safety related directives valid for his company
and country to make sure all requirements are met.
MPC5xxx / SPC5 14-pin 2.54mm Galvanic Isolation Adapter is used to electrically isolate:
·
iSYSTEM iC5700 BlueBox in conjunction with
·
14-pin 2.54 mm MPC5xxx Debug Adapter
(Ordering code IC50150) from the embedded
target.
Find more information on
. To reach
for technical support please visit
.
