Please Note:
When auto track is activated, the record time will pause a moment (still go on for about
1 minute) for each finished recorded track. The song is converting the format and transferring to your
USB device. The converting time depends on the file size of the song.
15
Note: When Recording from USB to CD, only the STOP button will work.
Entering Recording (Paused) Mode
2. Test play the audio source to be recorded and press “RECORD LEVEL(- OR +)” button to set the
recording volume so that its loudest output does not exceed the “OVER” indicator on the meter
on the lower right of the display.
Note:
Be sure not to set the recording volume too low – doing so will result in very low playback
volume levels.
3. Once the recording volume level is set, reset the audio source so it is ready for recording.
Entering Recording (Play) Mode
1. Press the PLAY/PAUSE ( ) button to begin recording.
( ) will appear on the left of the screen and “CD” will stay lit on the right of the screen,
indicating that recording is in progress.
2. Begin playing your audio source normally.
*Manual Track Increment Assignment
Note:
“The TRACK INCREMENT” button works regardless of the MANUAL/AUTO REC setting.
During recording, press the TRACK INCREMENT to end the current track and begin a new one.
The current track number will be indicated on the display.
To Pause Recording Temporarily (Recording Paused Mode).
Press the PAUSE button ( ). The recording process will be temporarily paused.
To resume recording, press the PLAY/PAUSE button ( ) again.
Important:
Every time recording is paused or stopped, a new track number will always be
assigned. It is not possible to record in two “stages” within one track.
3. Press the STOP button ( ) to stop recording.
Note:
When the rotation of the turntable stops, the recording will stop automatically. However, to
avoid unwanted noise from the tone arm, stop the recording manually by using the STOP button.
FINALIZING A CD
1) After pressing stop, press the “CD/USB” button repeatedly to select CD mode.
2) After pressing the “CD/USB” button, “---busy” will show on the display.
3) After the “busy” display is gone the Display will show the number of
tracks and duration of the recorded time on your CD.
4) Press the “FINALIZE” button and screen will say “FIN-dic”,
quickly press the “PLAY/PAUSE” button to begin finalization.
5) The CD will turn and you will have “busy” again showing on the display.
1.
Press the “RECORD” button to select CD Recording
Mode. (“ Rec” will appear on the left of the screen and
“---cd” will appear on the display.)
If an AUTO TRACK mode is selected, “AUTO TRACK” will
appear on the lower middle of the screen.
6. Press the AUTO/MANUAL button to assign a new track automatically. Press the AUTO/MANUAL
7. Then press RECORD button to beginning record, “REC” will show on the display.
button again to cancel.
Note : “---busy” will appear a few seconds on the display.
8. The “CD” will show and flash on the display, it indicates that recording mode is beginning.
9. The STOP button can cancel the recording at any time.
10. The display will show “ALL” and total track numbers after finished recording.
FIN-dic
NO TOC CD-R
