Italkero Falo Evo, User Manual And Assembly Instructions

25

UK

CAREFULLY LOOK AFTER THIS BOOKLET FOR THE ENTIRE LIFE OF THE APPLIANCE AND REQUEST A NEW ONE IN 

CASE OF DAMAGE OR LOSS!

IMPORTANT! SHOULD THE PARTS BE DAMAGED, DO NOT GO AHEAD WITH ASSEMBLY!

IMPORTANT! This appliance must be installed in compliance with the Regulations, Laws and Standards applicable in the 

Country of use. Install the appliance outdoors in a well ventilated area, the area around the appliance must have an open side 

of MIN 25% of the total area, the use must comply with the instructions provided by the manufacturer. Refer to the instructions 

before installing and using the appliance.

IMPORTANT! ALL the maintenance, repair or modification operations MUST be performed by professionally qualified and certi-

fied personnel and always using the Manufacturer’s original spare parts.

IMPORTANT! This gas-fuelled appliance is a heat generator intended only for the use for which it was designed and certified 

(with room temperature NOT below 0°C for Remote-controlled mod.), or as an appliance for heating open, ventilated or outdoor 

environments. All other uses are to be deemed improper and therefore hazardous. The Manufacturer disclaims all liability for 

any injury to persons or animals or damage to things caused by improper use.

IMPORTANT! If exposed to violent gusts of wind, provide adequate anchorage to the slab.

IMPORTANT! OPERATION IN CLOSED ENVIRONMENTS IS FORBIDDEN: OFFICES, INSIDE HOMES, STABLES, ANIMAL 

FARMS, PLACES NEAR GAS VAPOURS OR POTENTIALLY INFLAMMABLE DUSTS AND/OR EXPLOSIVES, ETC.

IMPORTANT! Carefully follow ALL the instructions and precautions indicated in this booklet (concerning INSTALLATION, USE 

and MAINTENANCE). Failure to abide by these instructions could cause malfunctions and or endanger people, animal and 

things.

IMPORTANT! THIS APPLIANCE IS GAS FUELLED AND PARTS OF IT BECOME HEATED. CONSEQUENTLY, KEEP IT OUT 

OF REACH OF CHILDREN.

IMPORTANT! NEVER move the appliance with the burner still operating.

IMPORTANT! ALWAYS COMPLY WITH SAFETY DISTANCES FROM OBJECTS OR INFLAMMABLE MATERIALS(Fig. 2).

IMPORTANT! TO ASSEMBLE AND USE, ABIDE BY THE FIRE-FIGHTING AND ACCIDENT-PREVENTION REGULATIONS OF 

THE COUNTRY WHERE THE APPLIANCE IS USED.

IMPORTANT! DO NOT use the appliance set for LPG in basements or cellars.

IMPORTANT! The appliance made to use LPG, CANNOT be fed with or modified to use natural gas and vice versa.

IMPORTANT! MODIFYING the appliance is absolutely forbidden except ONLY in those cases indicated and authorised by the 

Manufacturer.

IMPORTANT! Fit the gas pressure regulator on the cylinder (fixed-setting type) in conformity with the TECHNICAL DATA and 

GAS SETTING plates on the appliance (Tab. 1).

IMPORTANT! Every time the cylinder is changed and periodically, using soapy water or equivalent, make sure there are NO 

gas leaks from the pipes, from the cylinder connections, gas distribution connections and gas connection with the appliance. 

Replace the seal every time the cylinder is changed and periodically check the state of wear, efficiency, tube expiry data and all 

the connections.

IMPORTANT! Before making the connection, make sure the hose connector provided is in conformity with the Regulations appli-

cable in the Country of use.

IMPORTANT! Before proceeding with assembly operations, make sure all the parts making up the appliance are suitable for the 

type of gas and pressures according to the Regulations applicable in the Country of use.