Italkero INFRA Spider, User Manual And Assembly Instructions

START-UP

IMPORTANT! Remove all the protective films if fitted.
IMPORTANT!

To prevent any blaze-ups due to gas accumulation, allow 1 or 2 minutes to pass before

repeating the ignition procedure.

IMPORTANT! NEVER

start the appliance without first fitting the cover dish and fully completing

assembly. The burner unit must 

NEVER be covered or partially covered

.

IMPORTANT!

DO NOT cover the appliance if this has only just been switched off. Wait for it to cool down.

IMPORTANT!

Protect the appliance against knocks, strong humidity or rain.

IMPORTANT!

Always respect minimum installation distances and be careful that inflammable mate-

rials never come into direct contact with the appliance.

IMPORTANT! WHEN FIRST STARTED – IN THE OPEN AIR OR WELL-VENTILATED ENVIRONMENT –
THE APPLIANCE COULD GIVE OFF VAPOURS OR SMELLS FOR A SHORT TIME.

- Ignition

Regulation sequence, by pressing the button on the remote control or directly on the control unit:
ON, MAX, MEDIUM, MIN and OFF
1 – CONTROL UNIT: keep the ON/OFF button pressed for about 4” until ignition occurs. Once on, every time
the ON/OFF button is pressed, the appliance switches from MAX flame to MEDIUM  to MIN and finally to OFF.

IMPORTANT!

In case of having to use the ON/OFF button on the control unit on board the applian-

ce, always be careful never to come into direct contact with the flame or hot parts to avoid burns.
1b – REMOTE CONTROL: press the ON/OFF button to start the appliance. Once ignited, the required
flame/output can be chosen (MAX, MEDIUM and MIN) using the two keys + and – on the Remote Control.

IMPORTANT!

This delay in ignition is not a “fault” of the electronic control unit but has been specially

designed by the Manufacturer to ensure the safety of the appliance and prevent accidental starting.

IMPORTANT!

If the pilot flame goes out, accidentally or due to lack of gas, the gas supply will be

automatically interrupted by means of the installed safety device.

IMPORTANT! Avoid repeated ignition attempts: if the appliance does not operate immediately,
make sure ALL the installation operations have been performed correctly.
IMPORTANT!

During operation and also after switch off, DO NOT TOUCH the burner unit or the

cover dish. These are hot and could cause burns.
Power adjustment can also be made during appliance operation by means of the remote control or
using the button on the control unit.

IMPORTANT!

If the appliance is fuelled by LPG in the open air and with temperatures below 2°C the

use of Propane gas is recommended.

SWITCHING OFF

1 – Press the ON/OFF button on the Remote Control or on the control unit on board the appliance.
2 – Close the gas supply tap.

IMPORTANT! IF THE APPLIANCE IS NOT USED FOR A LONG PERIOD, REMOVE THE IGNITION
UNIT BATTERIES (Fig. 6: 7) AND THOSE OF THE CONTROL UNIT (Fig. 6: 22) FROM THEIR HOU-
SING, TO PREVENT CORROSIVE LIQUID LEAKING OUT AND CAUSING DAMAGE.

22

S U N f o x   I N F R A   S p i d e r   r e m o t e