9
Warning: Pedicure spa must be installed by a qualified, licensed plumber and electrician. Failure to comply may result
in serious injury and/or warranty will be voided.
GETTING STARTED
1)
Turn drain control knob and make sure the water stopper is tightly closed
2)
Turn on faucet (mixing valve) handle to fill water into tub as a minimum necessary water level (1/2”
above jet)
3)
Push/press air switch button to turn on jet(s)
4)
Adjust jet’s water pressure to a desirable flow
IMPORTANT NOTE
At no time must the jet and/or water discharge pump be turned on when the system is out of water, as damage may
occur, causing jet and/or water discharge pump to burn- out. Such damage is not covered by warranty.
DO NOT
use excess amount of solution to include but not limited to: soap or pedicure solution(s) etc, as high reaction
turbulence often caused excessive foaming.
SHUTTING DOWN
1)
Push/press air switch button to turn off jet(s)
2)
Turn drain control knob and check water stopper is opened
3)
If your spa has a water discharge pump, turn on to drain out water (remember to turn off pump)
4)
Sanitize tub per local and state requirements
IMPORTANT NOTE
Water discharge pump must be turned
OFF
after water had drained out.
DO NOT
let it runs dry.
MAINTENANCE
A quick sponge-down with warm water and a liquid detergent such as Mr. Clean, Fantastic, and Lysol, bathroom and/or
tile cleaner will take care of most cleaning needs. In areas where the water is hard, more frequent cleaning will be
necessary to avoid a build-up on the tub surface.
A good quality car or boat wax to be applied occasionally will preserve the glossiness and will help the cleaning a lot
easier.
CAUTION
DO NOT DROP HARD, HEAVY OBJECT ON SPA TUB SURFACE
DO NOT USE ROUGH/HARD CLEANING DEVICE(S) TO SCRUB DOWN SPA TUB SURFACE
ONLY USE SOFT TOWEL TO CLEAN SPA TUB
ALWAYS FOLLOW YOUR LOCAL/STATE CLEANING INSTRUCTIONS (IT’S THE LAW)
