5
FRANÇAIS
ENGLISH
N
o.
DESCRITPTION
QTY.
21
608 Bearing
1
22
Pin
1
23
Needle bearing
2
24
Double gear
1
25
Baffle
1
26
Screw ST4 X 55
1
27
Start
1
28
Bearing brush
1
29
Rating label
1
30
Brush cap
2
31
Carbon brush
2
32
Brush holder
2
33
Housing
1
N
o.
DESCRITPTION
QTY.
34
Brand label
1
35
Screw ST4 X 18
2
36
Handle cover
1
37
Switch
1
38
Screw ST4 X 16
2
39
Cord clamp
1
40
Cord cover
1
41
Power cord
1
42
Felt washer
1
43
Screw ST5 X 48
4
44
Washer 5
4
45
Washer 5
4
WARRANTY
ITC branded power tools, air nailers staplers and compressors are designed for
use in DIY (do-it-yourself), light or intermittent duty, semi-professional applications.
They are not intended for use in professional, production, industrial or continual use
applications.
ITC makes every effort to ensure that its products meet high quality and durability
standards and are warranted for two years against manufacturers’ faults and
defects for a period of two years from the date of purchase to the original owner.
ITC will REPAIR OR REPLACE (at our discretion) merchandise deemed by the
company to be defective, provided that it is has not been misused, abused, altered,
or repaired by anyone other than an authorized repair centre.
Please consult the ITC catalogue or your nearest ITC distributor to determine those
products that are covered by our over-the counter warranty. Any ITC tool that fails
during normal use and within the specified warranty period and qualifies for over-the
counter warranty must be returned to its point of purchase for replacement or credit.
Any item not listed as over-the-counter warranty must be shipped, prepaid freight,
to an authorized repair depot accompanied by a copy of the invoice specifying the
date that the item was purchased. Returned tools that are not accompanied by a
proof of purchase (Copy of Invoice) will not be repaired or replaced under warranty.
This warranty does not extend to normal wear or consumable parts such as brad
and staple gun driver blades, grinding discs, saw blades, driver bits, electric motor
brushes, worn chords, etc. It also does not apply to ITC tools used in professional,
production, industrial or continual use applications.
For a listing of the authorized repair centers please refer to the ITC catalogue.
PARTS LIST
Please refer to Schematic Drawing on page 19.
