011951
Page of 24
ENGLISH
®
!
!
MOUNTING ACCESSORIES
WARNING:
Disconnect the plug from the main socket
MOUNTING THE SAWBLADE
Loosen the Allen screw (
16, fig.E
) with the supplied Allen wrench and open the
top of the base plate.
Press the spindle lock and turn the spindle (
17, fig.E
) until it engages in the
lock. Keep the spindle lock pressed during this procedure.
Remove the flange nut (
18, fig.E
) from the spindle using the wrench (
19, fig.E
)
Position the sawblade (
20, fig.E
) on the flange. (
21, fig.E
)
Place the flange nut (
18
) from the spindle (
17
) and tighten it with the wrench
(
19
).
The flange nut has two sides. One for sawblades with bore 20 mm and the
other side for sawblades with bore 22 mm.
Pay close attention that the flange nut will be placed with the correct side on the
spindle.
Release the spindle lock and check that the spindle is unlocked by rotating it.
Close the top of the base plate and fasten the Allen screw (
16
) with the supplied
Allen wrench.
WARNING:
Make sure that the top of the base plate is securely closed before
operating the machine.
ALWAyS CHECk THE CUTTING DEPTH AFTER MOUNTING A SAW BLADE.
Disconnect the plug from the socket.
Move the motor base (
15, fig.F
) as far as possible backwards.
Set the cutting depth in the maximum position by turning the depth adjustment
knob. (
7, fig.F
)
Move the motor base forwards until the pin (
A, fig.F
) falls into the notch in the
adjustment knob (
7
).
Turn the saw blade until one tooth of the saw blade is in the front position.
Measure the distance from the side of the base plate to the tooth of the saw
blade.
Check if the distance is 18 mm. The maximum position is 18 mm.
SETTING THE CUTTING DEPTH
When cutting depth is not correct, it can be adjusted as follows:
Move the motor base (
15
) as far as possible backwards.
Loosen the pin (
A
)
Set the cutting depth by turning the screw. The screw is positioned at the back
of pin (
A
).
Repeat the procedure until the cutting depth is correct.
Fasten the pin (
A
).
1.
2.
3.
4.
5.
6.
7.
8.
9.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
