011951
Page of 24
ENGLISH
®
!
CUTTING GROOvES
Move the motor base backwards.
Place the machine against the workpiece.
Position the machine (see positioning the machine)
Hold the machine with both hands and switch the machine on.
Push the motor base carefully forward as far as possible.
Move the motor base backwards and switch the machine off.
jOINING WORkPIECES
When the grooves in both workpieces have been made, the workpieces can be
joined together.
Put glue in both grooves.
Place the biscuit in the groove of one workpieces.
Fit the other workpiece onto the biscuit.
Clamp the workpieces and wait until the glue is dry.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
MAINTENANCE
WARNING:
Make sure that the machine is not live and that it is unplugged when
carrying out maintenance work on the motor.
This tool has been designed to operate over as long period with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine
care and regular cleaning.
CLEANING
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off, use a soft cloth moistened with soapy water. Never
use solvents such as petrol, alcohol, and ammonia water, etc. These solvents
may damage the plastic parts.
OPERATING PROCEDURES
THIN WORkPIECES
(thinner than 16 mm)
Place the machine near the workpiece
Place the adjustment plate (
5, fig.J
) against the angle stop (
4, fig.J
).
Take care setting the height. The groove for the biscuit MUST be in the middle of
the workpiece.
NOTE:
On workpieces thinner than 16 mm, it is not possible to make the groove
for the biscuit in the middle of the workpiece without the aid of the adjustment
plate.
