8
ENGLISH
FRANÇAIS
FRANÇAIS
ENGLISH
8
ENGLISH
FRANÇAIS
FRANÇAIS
ENGLISH
5. Use a slender, soft steel rod to push the drive blade to its uppermost position.
6. Remove the jammed fastener with needle nose pliers.
7. Latch the FRONT PLATE (47) closed.
8. Follow instructions in LOADING THE FASTENERS to reload fasteners.
COMPRESSOR MAINTENANCE
WARNING:
BEFORE ANY MAINTENANCE OR ADJUSTMENTS TO YOUR AIR
COMPRESSOR, ALWAYS TAKE THE FOLLOWING SAFETY PRECAU
-
TIONS:
1. Disconnect electrical power.
2. Open the drain cock to drain air tank of pressure.
DRAINING THE OIL
1. Remove the oil drain plug (oil level sight glass). Allow oil to drain completely.
2. Replace the oil drain plug (we recommend the use of a sealing compound or
teflon tape to avoid leakage). Do not over-tighten.
3. Refill with the recommended oil to the red dot in the oil level sight glass.
DAILY MAINTENANCE
Before each use:
1. Check the oil level
2. Be sure all nuts and bolts are tight
3. Check for any unusual noise or vibration
After use:
open the air tank drain cock to drain condensation from tank
MONTHLY MAINTENANCE
1. Inspect air system for leaks by applying soapy water to all joints. Tighten those
joints if leakage is observed.
2. Check that all nuts and bolts stay tight.
250 HOURS OR SIX (6) MONTHS
(whichever comes first)
1. Change compressor oil (see compressor lubrication, above)
2. Paint spraying operations or dusty environments may require you replace oil
more often
CAUTION:
All air line components (including hoses, pipe, connectors, filters, &
regulators, etc.) must be rated for a minimum working pressure of 150 psi /
1034 kPa / 10.3 bar or 150% of the maximum system pressure, whichever is
greater.
=
Disconnect any tools from the air supply before performing maintenance,
clearing a jammed fastener, leaving the work area, moving the tool to another
location, or handing it to another person.
=
When cleaning air filter, or any parts in direct contact with the air production,
do not use any flammable or toxic cleaner or solvent
=
During the break in period, nuts and bolts have a tendency to loosen up. After
two weeks, tighten all nuts and bolts including head bolts.
SETUP & OPERATION
