FRANÇAIS
ENGLISH
FRANÇAIS
ENGLISH
FRANÇAIS
ENGLISH
FRANÇAIS
ENGLISH
4. Tighten the bolt with a suitable wrench and moderate force until the outlet is
securely attached.
5. Repeat the procedure at the other side.
CAUTION:
Dust may cause respiratory problems. Certain laminated board mate-
rials are carcinogenic. After work, always remove all dust from machine.
NOTE:
Turn off the switch and make sure the tool is unplugged before performing
any maintenance to the tool.
WARNING
:
Turn off your router at once, unplug and inspect it for serious problems if:
Moving parts get stuck
Speed drops to an abnormally low level
The motor housing gets hot
Sparks or odours emit from the casing
Keep the vents clear of dust and debris. This will help prevent possible
electrical shorts and ensure proper cooling.
Keep the tool housing and handle clean and free of oil and grease using mild
soap and a damp (not wet) cloth. Cleaning with solvents like brake fluid,
gasoline, petroleum-based products, etc. can harm the plastic and break down
the integrity of the double insulating system.
Avoid overloading your router. It will become hot and lose efficiency.
Inspect the cord regularly and have it replaced by an authorized repair facility
if it is damaged.
Lubrication for this tool is done at the factory and should not be necessary
again under normal use.
Check the router bit regularly for cracking and other damage. Do not use a
damaged bit.
An authorized repair centre should do any repairs, modification, or
maintenance that involve disassembling the router.
Any damage to the tool should be corrected at an authorized repair centre.
MAINTENANCE
WARRANTY
ITC branded power tools, air nailers staplers and compressors are designed for use in DIY (do-it-yourself), light or
intermittent duty, semi-professional applications. They are not intended for use in professional, production, industrial or
continual use applications.
ITC makes every effort to ensure that its products meet high quality and durability standards and are warranted for two
years against manufacturers’ faults and defects for a period of two years from the date of purchase to the original owner.
ITC will REPAIR OR REPLACE (at our discretion) merchandise deemed by the company to be defective, provided that it
is has not been misused, abused, altered, or repaired by anyone other than an authorized repair centre.
Please consult the ITC catalogue or your nearest ITC distributor to determine those products that are covered by our
over-the counter warranty. Any ITC tool that fails during normal use and within the specified warranty period and qualifies
for over-the counter warranty must be returned to its point of purchase for replacement or credit. Any item not listed as
over-the-counter warranty must be shipped, prepaid freight, to an authorized repair depot accompanied by a copy of the
invoice specifying the date that the item was purchased. Returned tools that are not accompanied by a proof of purchase
(Copy of Invoice) will not be repaired or replaced under warranty.
This warranty does not extend to normal wear or consumable parts such as brad and staple gun driver blades, grinding
discs, saw blades, driver bits, electric motor brushes, worn chords, etc. It also does not apply to ITC tools used in
professional, production, industrial or continual use applications.
For a listing of the authorized repair centers please refer to the ITC catalogue.
!
!
!