8
5.8.2. Baud rate testing
You could control the camera well by changing the Baud rate on the PC.
5.8.3 Controlling the cameras with different addresses
You could test several cameras together by changing the physical address of the
camera and then by controlling its moving in PC software.
5.8.4 The effect of system linking
Connecting one conference main controller, several conference discussion units
and the PC, then open the PC software to set the ID number and the presetting
bits of each unit. Then checking whether the working of the discussion units is
normal. Please turn on several discussion units and turn off them to see whether
the camera could point to the presetting bits automatically. Testing samples as
below:
1
）
When turning on the 1
st
to 5
th
discussion units continuously, the camera will
point to the 5
th
unit. Then turning off the 5
th
unit, the camera will point to the 4
th
unit. Turning off the units continuously and finally when you turn off the 1
st
unit,
the camera will point to the panoramic position.(Panoramic position is setted by
PC software and before click the confirmation, the camera position should be
adjusted.)
2
）
Turning on the 1
st
to 5
th
discussion units, the camera will point to the 5
th
unit.
Then turning off the 2
nd
, 3
rd
and 4
th
units, the camera will not moving at this
time. Turning off the 5
th
unit, the camera will point to the 1
st
unit then.
3
）
When tuning on the 1
st
to 5
th
units, the camera will point to the 5
th
unit. Then
press the priority button on the 6
th
chairman unit, all the units will be off at this
time and the camera will point to the 6
th
chairman unit. The same testing
method to TS and TH series.
