2. Press the button for 7 seconds until the green LED fast blinks. Due to
this model has used different firmware and module, the led has two
blinking ways.
Open eWeLink, click”+”, you’ll see the pairing icons. Please select the
pairing mode according to below instructions:
If the led blinks like this:
please select
Quick Pairing Mode
(TOUCH)
, tap
Next
.
If the led blinks like this:
a. If the device firmware is
1.6.0 or higher
, please select
Quick Pairing
Mode (TOUCH)
. Otherwise, it will fail to add the device. Click
Next
.
b. If the firmware of above models is
lower than 1.6.0
, please
select
Compatible Pairing Mode (AP)
icon, click
Next
. iOS users
should go to Phone Setting>WiFi>connect the WiFi begins with ITEAD-
******, enter default password 12345678. Go back to eWeLink, click next.
3. It will auto-search and connect smart home device around you.
4. It will auto select your home SSID, please enter password:
4.1 If no password, keep it blank.
