MULTIMIX 8/4 DIGITAL
www.itec-audio.com
MULTIMIX 8/4 DIGITAL
5) Fix the module with two screws
6) Reinsert the top and bottom cover
B) Software settings
1) Connect the Multimix 8/4 digital with a computer and make sure the device is switched on.
2) Run MixDesign (At least Version 2.0)
Go to “
Extras
”|”
Hardware setup
” and click menu item "
Input Equalizer is installed
"
Note: If the item is disabled, go to “Extras”|”MixDesign preferences” and check the item
"Enable hardware setup changes" in "Other options"
Removing the Input-Equalizer Module
A) Hardware removal
1) Remove the top and bottom cover of the device (8 screws for each side)
2) Remove the Input-Equalizer module
3) Insert 8 jumpers at the Input section (JP1..JP8, the pin on the right side is unconnected)
4) Reinsert the top and bottom cover
B) Software settings
1) Connect the Multimix 8/4 digital with a computer and make sure the device is switched on.
2) Run MixDesign (At least Version 2.0)
Go to “
Extras
”|”
Hardware setup
” and click menu item "
Input Equalizer is not installed
"
Installing/Removing the LAN Module
A LAN module is a fixed part of a device and can´t be installed or removed by the user.
19
