Basic
operation
Copyright © ITECH Electronics Co., Ltd.
27
The terminals at rear panel of IT6160B.
3.12.1 Remote sense
Remote voltage sensing is used to maintain good regulation at the load and reduce
the degradation of regulation that would occur due to the voltage drop in the leads
between the power supply and the load. By connecting the supply for remote
voltage sensing, voltage is sensed at the load rather than at the supply's output
terminals. This will allow the supply to automatically compensate for the voltage
drop in the load leads and improve regulation.
Local sense
Local sense doesn’t compensate for the voltage drop on the wire, the operation is:
1. Use the shorting clip already installed on the rear panel, or install wires
between Drive+ and Sense+, Drive- and Sense-.
2. Connect the positive and negative terminals on the front panel or the Drive +
Drive- terminalson the rear panel to the device under test (DUT).
Wiring
Schematic
Diagram
of
Local
Measurement
of
IT6121B/IT6122B/IT6123B/IT6132B/IT6133B is as follows:
Wiring Schematic Diagram of Local Measurement of IT6162B/IT6164B is as
follows:
