Remote Control
Copyright ©ITECH Electronic Co., Ltd.
95
plies as for the IP Address. A value of 0.0.0.0 indicates that no default gate-
way is defined.
⚫
Socket Port: This value indicates the port number corresponding to the
service.
How to Configure
Take manual configuration as an example. The steps are as follows:
1.
Press the composite keys
[Shift]+
（
System
）
on the
front panel to enter the system menu.
2.
Select
Communication
and press
[Enter].
3.
Press the Left/Right key to select
LAN
and set the mode to
Manual
.
4.
Set the
IP
,
Mask
and the other parameters in turns, and press
[Enter]
.
9.3 CAN Interface
The CAN interface is located on the rear panel of the instrument and is con-
nected to the computer using a CAN communication cable.
Definition of CAN Pins
The definition of CAN pins are as follows.
Pins
Description
H
CAN_H
L
CAN_L
CAN Configuration
The user needs to configure the CAN interface parameters in the system
menu before using the remote control. The CAN interface parameters are as
follows.
Address
Range: 0 – 127
Baud rate
Select the baud rate from the following options:
5k/10k/20k/40k/50k/80k/100k/125k/200k/250k/400k
/500k/600k/800k/1000k
The operation steps are as follows.
1.
Press the composite keys
[Shift]+
（
System
）
on the front
panel to en- ter the system menu.
2.
Select
Communication
and press
[Enter]
.
Name
Description
