27
If the adjustment of the valves does not produce the
desired air flow, you can increase the maximum speed of
the ventilation unit by further opening the potmeter of the
maximum speed (see section
Setting the capacity
).
Note
After power-up, the ventilation unit is in log-on mode
for 2 minutes. However, during this time, the
ventilation unit responds to all log-in requests within
its range, so that it is possible that another RF
controller or RF sensor may be logged on to your
ventilation unit undesirably. As a result, your
ventilation unit responds not only to your own RF
control or RF sensor, but also to that of an adjacent
home.
ä Attention
!
If an RF control or RF sensor of an adjoining house
has been logged into your ventilation system
undesirably, you can solve this by logging out an
already logged in control and logging in again. By
logging off one control, all controls and sensors are
logged off, including those of the adjoining house.
Summary of Contents for 03-00398
Page 1: ...Installation use Itho Daalderop CVE S ECO D...
Page 2: ...Original document...
Page 12: ...12...
Page 22: ...22 ithodaalderop 4 Operation 1 2 3 Q 0 4 5 6 0 J 000 S...
