28
5.1. Adjusting capacity
are reflected in the system design calculations or flow
measurements.
a)
Remove the lid by using a flat screwdriver to unlock
the clamping cams at the top and bottom. After this
you can remove the lid.
On the base board there are two potmeters for adjusting
the minimum and maximum capacity or low and high
level. Whether these capacities have to be adjusted
Tip
If the capacity has to be increased, first try to open
the air valves further to achieve the required
capacity. Increasing the motor speed will result in
higher energy consumption and noise levels.
ä Attention
!
The capacities (high and low position) of the
ventilation unit must be adjusted during
commissioning!
Summary of Contents for 03-00398
Page 1: ...Installation use Itho Daalderop CVE S ECO D...
Page 2: ...Original document...
Page 12: ...12...
Page 22: ...22 ithodaalderop 4 Operation 1 2 3 Q 0 4 5 6 0 J 000 S...
