33
6.2.4. Inspecting/cleaning channels
It is advisable to check the channels in the house once
every 4 years. The ducts should be cleaned once every 8
years.
Clean the valves as follows.
In case of slight soiling, wipe the valves with a slightly
damp cloth. If necessary, use a solution of a mild
detergent such as washing-up liquid or all-purpose
cleaner. In case of strong adhesion of dirt, remove the
valves completely from the canal.
a)
Remove the foam sealing tape.
b)
Completely immerse the valves in a solution of a
mild detergent (e.g. dish soap or all-purpose
cleaner). If necessary, the valves can be cleaned in
the dishwasher.
c)
Remove the valves with a cloth or soft brush.
d)
Dry the valves. Place the foam sealing tape
back on the valve.
e)
Place each valve back into the duct of origin.
ä
Warning!
Disconnect the unit, or remove the motor plate,
when cleaning the ducts so that the unit does not get
dirty inside (RV sensor)!
ä Attention
!
When cleaning, do not adjust the setting of the
valves and put the valves back in the duct of origin.
Summary of Contents for 03-00398
Page 1: ...Installation use Itho Daalderop CVE S ECO D...
Page 2: ...Original document...
Page 12: ...12...
Page 22: ...22 ithodaalderop 4 Operation 1 2 3 Q 0 4 5 6 0 J 000 S...
