ITK ADMIN AN-PM13-24-18C13-06C19-41, Manual

3

To use the unit with mechanical damages of the flexible cable, socket case or plug

The unit is equipped with low-profile hydraulic electromagnetic circuit breakers (hereinafter 

referred to as circuit breakers) to prevent overcurrent and to ensure stable operation.

The main technical data of the units are given in the tables 1

–

4.

If a malfunction is detected after the warranty period expires, dispose of the product.

Safety precautions

Basic product data

Technical data

IT IS FORBIDDEN

The unit with sockets of C13 type according to IEC 60320-1 is equipped with a latching device to 

prevent the plug from falling out of the socket by itself. The latching device is installed only for the 
units AN-PM13-24-18C13-06C19-41, AN-PM13-24-21C13-03C19-41, 

Ñ

N-PM23-24-18C13-

06C19-41, 

Ñ

N-PM23-24-21C13-03C19-41, AN-PM33-24-18C13-06C19-41, AN-PM33-24-

21C13-03C19-41, 

Ñ

N-PM43-24-18C13-06C19-41 

è

Ñ

N-PM43-24-21C13-03C19-41.

The Network Management and Control Module (hereinafter-NMC module) and socket modules 

can be removed from the unit when the power is on for easy replacement and maintenance, or to 
make different combinations of the number of sockets by the modules in the unit.

Power distribution unit of PDU type with monitoring and general monitoring of ADMIN series, with 

monitoring, general monitoring and control of CONTROL series of ITK trademark (hereinafter 

–

 unit) 

is designed for power distribution in server racks, data processing centers etc. This unit is 
additionally equipped with a control and monitoring module with the possibility of remote control and 
management.

Independent power source for the NMC module ensures operation even if the circuit breaker 

trips when overloaded.

The NMC module, as well as the purpose of the controls, ports and light indicators on the front 

panel of the module are shown in figure 1

Completeness of set

External appearance and dimensions* of the units are shown in figures 2

–

6.

The product delivery set is shown in the table 

5

.

To connect the load to unit that exceeds the permissible horsepower specified 

in tables 1

–

4.

To connect the unit to a damaged electrical socket.

All works on installation and maintenance of the product should be carried out in a de-energized 

state by specially trained personnel while meeting the requirements of reference documentation in 
the field of electrical engineering.

At the end of its service life, dispose of the product.

ADMIN POWER DISTRIBUTION UNIT OF PDU TYPE 
WITH MONITORING AND GENERAL MONITORING, 
CONTROL POWER DISTRIBUTION UNIT OF PDU TYPE 
WITH MONITORING, GENERAL MONITORING AND CONTROL

Passport

AN.

Ñ

N.001.1

EN

* Limit deviation of width dimensions is ±0,5 mm. Limit deviation of length dimension is ±3,0 mm.