Ti300 PRO, Ti400 PRO, Ti401 PRO Ti450 PRO, Ti450 SF6, Ti480 PRO
Users Manual
10
Basic Operation
Turn On and Off the Imager
Before you use the Imager for the first time, charge the battery for a minimum of two and one-half hours. See
To turn on or turn off the Imager, push and hold
for 2 seconds.
To maximize the life of the battery, use the Power Save and Auto Off features. See Table
about how to set these features.
Note
All thermal imagers need sufficient warm-up time for accurate temperature measurements and best
image quality. Warm-up time can vary by model and environmental conditions. Although most imagers
are fully warmed up in 3 minutes to 5 minutes, wait a minimum of 10 minutes if the most accurate
temperature measurement is important to your application. When you move an Imager between
environments with large differences in ambient temperature, allow for additional adjustment time.
Focus
Correct focus makes sure that the infrared energy is correctly directed onto the pixels of the detector. Without
correct focus, the thermal image can be blurry and the radiometric data may be inaccurate. Out-of-focus infrared
images are frequently unusable or of little value.
To focus with the advanced manual focus system, rotate the Manual Focus Control until the inspection object is
in proper focus. Use the advanced manual focus system as an override to the LaserSharp Auto Focus System.
See
Capture Image
To capture an image:
1. Focus on a target.
2. Pull and release the
Primary Trigger
or double tap on the display to capture and freeze the image.
The image is in the memory buffer for you to save or edit the image. To edit an image, see
.
Depending on the selected file format settings, the Imager shows the captured image and a menu bar. The
menu bar shows the available options.
Note
MultiSharp Focus captures and freezes images differently. See
www.
.com
information@itm.com
1.800.561.8187
